background image

1

KD-DV5304/KD-DV5303/

KD-DV4304/KD-DV4303

Installation/Connection Manual

GET0440-002A

[UI]

1206DTSMDTJEIN

EN

This unit is designed to operate on

 12 V DC, NEGATIVE ground electrical systems

. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.

WARNINGS

•  DO NOT install any unit in locations where;

– it may obstruct the steering wheel and gearshift lever operations.
– it may obstruct the operation of safety devices such as air bags.
– it may obstruct visibility.

•  DO NOT operate the unit while driving. 
•  If you need to operate the unit while driving, be sure to look ahead carefully.
•  The driver must not watch the monitor while driving.
  If the parking brake is not engaged, “DRIVER MUST NOT WATCH THE MONITOR WHILE DRIVING.” appears on the monitor, and no playback picture will be shown.

– This warning appears only when the parking brake wire is connected to the parking brake system built in the car.

To prevent short circuits, we recommend that you disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

•  Be sure to ground this unit to the car’s chassis again after installation.

Notes:

•  Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.
•  It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 

 to 8 

). If the maximum power is less than 50 W, change 

“AMP GAIN” setting to prevent the speakers from being damaged (see page 24 of the INSTRUCTIONS).

•  To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
•  The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.

PRECAUTIONS on power supply and speaker connections:

•  DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.

•  BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.

Heat sink

© 2006 Victor Company of Japan, Limited

J

Rubber cushion

F

Crimp connector

G

Washer (ø5)

H

Lock nut (M5)

I

Mounting bolt (M5 

×

 20 mm)

Parts list for installation and connection

If any item is missing, consult your JVC car audio dealer immediately.

K

Handles

L

Remote controller

M

Battery

A

 / 

B

Hard case/Control panel

C

Sleeve

D

Trim plate

E

Power cord

Instal1-2_DV5304_002A_pre.indd   1

Instal1-2_DV5304_002A_pre.indd   1

12/5/06   11:25:05 AM

12/5/06   11:25:05 AM

Содержание KD-DV5304

Страница 1: ...assis again after installation Notes Replace the fuse with one of the specified rating If the fuse blows frequently consult your JVC car audio dealer It is recommended to connect to the speakers with maximum power of more than 50 W both at the rear and at the front with an impedance of 4 Ω to 8 Ω If the maximum power is less than 50 W change AMP GAIN setting to prevent the speakers from being dama...

Страница 2: ... 8 mm long screws If longer screws are used they could damage the unit Install the unit at an angle of less than 30 TROUBLESHOOTING The fuse blows Are the red and black leads connected correctly Power cannot be turned on Is the yellow lead connected No sound from the speakers Is the speaker output lead short circuited Sound is distorted Is the speaker output lead grounded Are the terminals of L an...

Страница 3: ...rd 3 Finally connect the wiring harness to the unit 15 A fuse Black Blue with white stripe Red Yellow 2 To metallic body or chassis of the car Ignition switch Fuse block To an accessory terminal in the fuse block To the remote lead of other equipment 200 mA max To a live terminal in the fuse block connecting to the car battery bypassing the ignition switch constant 12 V 1 Not supplied for this uni...

Страница 4: ...nna if any Front speakers Required connections for DVD playback Audio video control amplifier or the decoder compatible with the multichannel digital sources KV MR9010 9 INCH WIDESCREEN MONITOR 3 Digital optical cable 3 Apple iPod JVC D player CD changer jack You can connect these components as illustrated below The iPod or D player can be connected using an interface adapter not supplied KS PD100...

Отзывы: