ENGLISH
- 21 -
Picture Mode
Picture mode OSD is displayed when BLUE
button is pressed. Picture mode can be
changed to standard, soft, and bright.
Sleep Timer
Sleep Timer mode OSD is displayed when
YELLOW button is pressed.
The Sleep Timer is used to turn the TV off after
a defined period of time after selecting this item.
The timer can be programmed between Off and
120 minutes in steps of 10 minutes. (OFF, 010,
020, 030, 040, ... , 120)
If sleep timer is activated, at the end of the se-
lected the time, the TV goes automatically to
stand-by mode.
Mute Indicator
It is placed in the upper middle of the screen
when enabled, and it stays there until it is dis-
abled.
To cancel mute, there are two alternatives; the
first one is by pressing the " " button, this vol-
ume is set to the preceding value, and the sec-
ond one is increasing the volume level. By de-
creasing the volume level in mute state, mute
will not be ignored, only the volume level will
decrease.
No-Signal Detection (TV mode)
If no valid signal detected, it takes 5 minutes
to switch to the Stand-By mode unless any sig-
nal detected or any Remote Control command
is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal detected again the timer is initialized to
5 minutes and starts 3 seconds later again to
count down.
It is not valid in EXT modes.
No-Signal and Out Of Range
Detection (PC mode)
In PC Mode,as no menu is displayed,in case
that there is no PC input to the TV,it is displayed
an OSD message:
No input signal detected
then the power lamp turns to amber and PC
will be in PC standby mode. Press AV button,
digit buttons or
/
buttons to exit
standby mode.
In PC Mode,as no menu is displayed,in case
that there is no PC input to the TV, but the reso-
lution and the vertical frequency is not sup-
ported by the concept, it is displayed an OSD
message:
Signal out of range
Volume Bar
It is displayed in the lower middle of the screen.
When a volume command is received (press-
ing
+
or
-
by Remote Control or
Control panel at the top of the TV) and no menu
is active, it stays on the screen for 3 seconds,
after the last volume command or until another
command is received in between.
EXT Modes
By pressing the
AV
button you can switch your
TV to EXT modes (except being in Teletext).
Pressing this button will consecutively switch
the TV in one of the optional EXT modes:
EXT-1, EXT-2, EXT-2 S, EXT-3, EXT-4,
EXT-4 S
and
PC
.
In order to quit the EXT mode press any digit
buttons or
or
Zoom Modes
Zoom mode can be changed by pressing Red
button. You can change the screen size ac-
cording to the picture aspect ratio. Select the
optimum one from the following
ZOOM
modes.
01-ENG-20710W-17MB08P-1860UK-(LT-20A61SU)-(12V)-50093488.p65
21.09.2006, 10:31
21
