1-26 (No.MB014)
3.2.10 Removing the rack holder assembly/ sensor assembly
(See Fig.28 ~ 33)
• Prior to performing the following procedure, remove the tray
assembly, side (L)/ side (R) assembly, lifter assembly.
Attention:
If the slide gear of the body places at joint
w
of the rack holder
assembly, turn the 1 gear counterclockwise to move the slide
gear toward the front. Remove the rack holder assembly.
(1) Remove the three screws
J
attaching the rack holder as-
sembly. Release joint
w
from the notch.
Caution:
When reattaching the rack holder assembly, do not nip
the wire x extending from the sensor assembly.
(2) Remove the two screws
M
attaching the sensor assembly.
(3) Move the sensor assembly in the direction of the arrow to
release from the slot at joint
y
.
(4) Remove the spring attached to the bottom of the sensor as-
sembly from the boss
z
on the sensor slider.
(5) Remove the screw
N
and
O
attaching the sensor board and
SV resister respectively.If necessary, unsolder the sensor
board.
Caution:
When reattaching the SV resister, attach the sensor slider to
the sensor bracket and fit the lever on the bottom of the SV re-
sister into slot
a’
of the sensor slider.
Caution:
When reattaching the rack holder assembly, turn the 1 gear
clockwise to move the slide gear and slide lever inside the
body rearward.
• Let the wire extending from the sensor assembly through notch
x
to the bottom of the body.
• Fit pin
c’
of the slide lever into hole
b’
of the sensor slider on
the bottom of the sensor assembly while attaching the spring
to the boss
z
of the sensor slider.
• Engage joint
y
of the sensor assembly to the notch of the body.
Fig.28
Fig.29
w
L
L
L
1 gear
Rack holder
assembly
x
w
w
Rack holder
assembly
Rack holder
assembly
