1-16 (No.YD002)
3.2.4 Removing the loading motor (See Figure 3-2k and Figure 3-2l)
• Prior to the following procedure, remove the tray, the traverse
mechanism assembly, and the elevator.
(1) Remove the belt from the pulley.
(2) Remove two screws
C
attaching the loading motor.
(3) Remove two solders
h
on the switch board.
Fig.3-2k
Fig.3-2l
3.3 Traverse mechanism assembly
3.3.1 Removing the pickup (See Figure 3-3a, Figure 3-3b)
• Prior to the following procedure, remove the traverse mecha-
nism assembly.
(1) Remove one screw
D
attaching the plate.
(2) Remove the plate and the leaf spring.
(3) Lift
i
of the shaft
1
, and pull out the shaft
1
from
j
.
(4) Remove
k
of the pickup from the shaft
2
.
Attaching the pickup:
(1) Engage
k
of the pickup to the shaft
2
.
(2) Insert the shaft
1
in
j
, and attach the shaft 1 to
i
.
(3) Attach the leaf spring, and then attach the plate. Fix the
leaf spring and the plate by using the screw
D
.
Fig.3-3a
Fig.3-3b
Loading base
Slide cam
Belt
C
C
Pulley
Pulley
Loading motor
Switch board Part
h
D
Plate
Leaf spring
Part i
Shaft 1
Shaft 2
Part k
Part j
www.freeservicemanuals.info
3/7/2017
Digitized in Heiloo Netherland
