44
?
– –:– –
1
2
3
4
6
5
7
8
9
0
2
4
1
3
SUBSIDIARY SETTINGS (cont.)
Video
Channel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
With AV or S-VIDEO
Connection
ACCESS VIDEO CHANNEL
SET MODE
1
Press and hold down
STOP
on the recorder until the
display panel shows the following.
SET VIDEO CHANNEL
2
Press
PR
–
until the display panel shows "–OUT– –".
●
Now the video channel is set to off.
EXIT VIDEO CHANNEL SET
MODE
3
Press
OK
.
To view picture signals from the video recorder, set
your TV to its AV mode. Refer to the instructions
supplied with your TV set for how to do this.
●
If you have connected the video recorder to
your TV via both the provided RF cable and a
21-pin SCART cable (AV connection), or via
the provided RF cable, an S-Video cable and
an audio cable (S-VIDEO connection), you do
not need the video channel so you have to set
the video channel to off. — Go to "With AV or
S-VIDEO Connection" below.
●
If you have connected the video recorder to your
TV via the provided RF cable only (RF connection),
you have to set the correct video channel — Go to
"With RF Connection" on page 45.
Before performing the following procedure, make
sure that:
n
the mains power cord is plugged into the mains outlet.
n
the video recorder is turned off and there is no cassette
inserted in the recorder.
n
batteries have been installed in the remote control.
OK
IMPORTANT
Perform the following steps only if —
— Video Channel Set has not been done correctly by the
Auto Set Up function (
Z
pg. 8).
— interference appears in the TV picture after you have
moved to a different area or a new station has started
broadcasting in your area.
— you change the connection between your recorder and
TV from RF connection to AV or S-VIDEO connection,
or vice versa.
PR
STOP