19
CAUTIONS
LCD Monitor
1) To prevent damage to the LCD monitor, DO
NOT…
… push it strongly or apply any shocks.
… place the camcorder with the LCD monitor on the
bottom.
2) To prolong service life…
… avoid rubbing it with coarse cloth.
3) Beware of the following phenomena for LCD
monitor use. These are not malfunctions:
•
While using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
monitor may heat up.
•
If you leave power on for a long time, the surface
around the LCD monitor becomes hot.
For Your Maintenance
1) After Use
1
Turn off the camcorder.
2
Open the LCD monitor to an angle of over 60
degrees.
Press EJECT for approximately 2 seconds to
open the cassette holder, then remove the
cassette.
3
Close and lock the cassette holder by pressing
the Close button.
4
Close and lock the LCD monitor.
5
Slide BATTERY RELEASE to remove the
battery pack.
6
Attach the provided lens cap to the
camcorder’s lens.
2) Cleaning The Camcorder
1
Gently wipe the exterior with a soft cloth, with
diluted mild soap, wipe off heavy dirt, then
wipe again with a dry cloth.
2
Wipe the LCD monitor gently with a soft cloth.
Be careful not to damage the monitor. Close
the LCD monitor.
Serious malfunctioning
3
Blow the lens with a blower brush, then wipe it
gently with lens cleaning paper.
4
Remove dust from the viewfinder using a
blower brush.
• Avoid using strong cleaning agents such as
benzine or alcohol.
• Cleaning should be done only after the
battery pack has been removed or other
power units have been disconnected.
• Mold may form if the lens is left dirty.
• When using a cleaner or chemically treated
cloth, refer to the cautions that came with it.
About moisture condensation…
• You may have observed that pouring a
cold liquid into a glass will cause drops of
water to form on the glass’ outer surface.
This same phenomenon occurs on the
head drum of a camcorder when it is
moved from a cool place to a warm place,
after heating a cold room, under
extremely humid conditions or in a place
directly subjected to the cool air from an
air conditioner.
• Moisture on the head drum can cause
severe damage to the video tape, and can
lead to internal damage to the camcorder
itself.
If malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.
This device complies with Part 15 of FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
Changes or modifications not approved by JVC
could void the user’s authority to operate the
equipment. This equipment has been tested
and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/
TV technician for help.
GR-SXM38-EN.fm Page 19 Friday, December 23, 2005 11:43 AM
