JVC GR-SXM335U, Руководство по обслуживанию

Страница: 49 / 123

1-13
1.6 TAKE OUT CASSETTE TAPE
In the event that the set enters the emergency mode as it is
loaded with a cassette tape and the cassette tape cannot
be ejected with the EJECT button, manually, take it out of
the set according to the following procedure.
Note: If the mechanism comes into the unloading mode as
the cassette tape is not held by hand, it results in tape
damage.
1. Disconnect the set from the power source.
2. Remove the cassette cover assembly, Upper case,
Lower case assembly, Top operation assembly, Monitor
assembly (See Fig. C1, C2, C3, C5 and C8, Page 1-1
to 1-6).
3. Connect a jumper wire to each pole of the loading motor
as shown by the magnified view b (Fig. 1-6-1)
4. While holding down the cassette housing by hand, con-
nect the jumper wires to a battery to run the mechanism
to the EJECT position four unloading. If this unloading
operation is performed as the cassette housing is not
held down by hand, the front lid of the cassette may
damage the tape when it is ejected.
5. For taking in the slack of the tape, run the mechanism
to the EJECT position as the front lid of the cassette is
left open, and turn the take-up gear in the forward di-
rection to wind up the tape. After confirming that the tape
has completely been wound up and the supply reel is
idling, take the cassette tape out of the cassette hous-
ing.
Fig. 1-6-1
Magnified view
b
Battery
Take-up gear
Top view