46
EN
M 0 : 12 : 34
w
USING THE REMOTE CONTROL UNIT
(cont.)
Insert Editing
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:
Use the RM-V700U or RM-V705U remote control unit to
perform this procedure.
1
SELECT OPERATION MODE
Set the Power Switch to “PLAY”.
2
FIND EDIT-OUT POINT
Play back the tape, locate the point and press
PAUSE
on the camcorder or the remote control.
3
RESET COUNTER
Press and hold
COUNTER R/M
for more than
1 second to reset the tape counter, then press again
for less than 1 second so that “M” appears.
4
FIND EDIT-IN POINT
Press
REW
to go a little beyond the beginning of the
scene you want to replace, press
PLAY
to view the
recorded tape, and press
PAUSE
exactly at the
point where the new scene should start.
5
ENGAGE INSERT EDITING MODE
Press and hold
INSERT
, and without releasing
INSERT
, press and release
PAUSE
. The Insert Editing
mode is engaged. When the scene the camcorder is
aimed at appears on the screen, go to the next step.
6
BEGIN INSERT EDITING
Press
START/STOP
. When the counter reaches
“0:00:00”, editing stops automatically and the
camcorder enters the Insert-Pause mode.
7
END INSERT EDITING
Press
STOP
.
NOTES:
●
After step
5
, Retake (
Z
pg. 15) can be performed.
●
The tape may stop slightly before or after the designated
end point, and noise bars may appear. Neither indicates
a defect in the unit.
●
Only the video signal is recorded in the Insert Editing
mode.
RM-V700U (provided with
GR-FX53, optional for
GR-FX43/FX33/FX23)
Insert editing
indicator
Display
COUNTER R/M Button
Tape Counter
REW (
2
) Button
FF (
3
) Button
PLAY/PAUSE (
4
/
6
) Button
STOP (
5
) Button
Remote sensor
Power Switch
RM-V705U
(provided with
GR-FX43)
REW
START/STOP
PLAY
STOP
REW
INSERT
PAUSE
