EN
6
Automatic Demonstration takes place when
“DEMO MODE” is set to “ON” (factory-preset).
䡲
Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch
u
is set to “
” or “
”
and no cassette is in the camcorder.
䡲
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
䡲
“DEMO MODE” remains “ON” even if the camcorder power is
turned off.
䡲
To cancel Automatic Demonstration:
1.
Set the Power Switch
u
to “
” while pressing down the Lock
Button
y
located on the switch and press the
MENU/VOLUME
wheel
%
in. The Menu Screen appears.
2.
Rotate the
MENU/VOLUME
wheel
%
to select “
(SYSTEM)”
and press it.
3.
Rotate the
MENU/VOLUME
wheel
%
to select “DEMO MODE”
and press it. The Sub Menu appears.
4.
Rotate the
MENU/VOLUME
wheel
%
to select “OFF” and press
it.
5.
Rotate the
MENU/VOLUME
wheel
%
to select “
RETURN”,
and press it twice. The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration activated on
the LCD monitor or viewfinder.
AUTOMATIC DEMONSTRATION
None
RETURN
OF F
ON
EMO MODE
D
–
S
Y
S
TEM
u
%
y
Sub Menu
Attach the Core Filter(s) (if provided with your model
墌
pg. 5) to an optional cable(s). The Core Filter reduces
interference.
HOW TO ATTACH THE CORE FILTER
1
2
3
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx. 3 cm
of cable between the cable plug and the Core Filter. Wind
the cable once around the outside of the Core Filter as
shown in the illustration.
• Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
䡲
When connecting cables, attach the end with the Core Filter to the camcorder.
Wind once
1 GR-D91US EN 01-11
02.11.6, 2:10 PM
6