56
EN
CAUTIONS
(cont.)
3. DO NOT leave the unit . . .
..... in places of over 50°C.
..... in places where humidity is extremely low.
(below 35%) or extremely high (above 80%).
..... in direct sunlight.
..... in a closed car in summer.
..... near a heater.
4. To protect the unit, DO NOT . . .
..... allow it to become wet.
..... drop the unit or strike it against hard objects.
..... subject it to shock or excessive vibration during
transportation.
..... keep the lens directed at extremely bright
objects for long periods.
..... direct the eyepiece of the viewfinder at the sun.
..... carry it by holding the viewfinder or the LCD
monitor. Be sure to hold the main unit with both
hands or use the grip.
..... swing it excessively when using the shoulder
strap.
LCD monitor
1. To prevent damage to the LCD monitor, DO
NOT . . .
..... push it strongly or apply any shocks.
..... place the camcorder with the LCD monitor on
the bottom.
2. To prolong service life . . .
..... avoid rubbing it with coarse cloth.
3. Be aware of the following phenomena for LCD
monitor use. These are not malfunctions . . .
• While using the camcorder, the surface around the
LCD monitor and/or the back of the LCD monitor
may heat up.
• If you leave power on for a long time, the surface
around the LCD monitor becomes hot.
About moisture condensation . . .
●
You may have observed that pouring a cold
liquid into a glass will cause drops of water to
form on the glass’ outer surface. This same
phenomenon occurs on the head drum of a
camcorder when it is moved from a cool
place to a warm place, after heating a cold
room, under extremely humid conditions or
in a place directly subjected to the cool air
from an air conditioner.
●
Moisture on the head drum can cause severe
damage to the video tape, and can lead to
internal damage to the camcorder itself.
Serious malfunctioning
If malfunctioning occurs, stop using the unit
immediately and consult your local JVC dealer.
For Your Maintenance
1. After Use
1
Set the power switch to “POWER OFF” to
turn off the camcorder.
2
Press EJECT to open the cassette holder, then
remove the cassette.
3
Close and lock the cassette holder by pressing
PUSH.
4
Close and lock the LCD monitor.
5
Slide BATT. RELEASE to remove the battery
pack.
6
Slide the LENS COVER open/close switch to
close the lens cover.
2. Cleaning The Camcorder
1
CLEAN EXTERIOR
Wipe gently with a soft cloth.
2
CLEAN LCD MONITOR
Open the LCD monitor and wipe gently with
soft cloth. Be careful not to damage the
monitor. Close the LCD monitor.
3
CLEAN LENS
Blow it with a blower brush, then wipe gently
with lens cleaning paper.
4
REMOVE EYEPIECE
Turn the eyepiece counterclockwise and pull
it out.
5
CLEAN VIEWFINDER
Remove dust using a blower brush.
6
RE-ATTACH EYEPIECE
Align the marks, re-attach the eyepiece and
turn it clockwise.
NOTES:
●
Avoid using strong cleaning agents such as
benzine or alcohol.
●
Cleaning should be done only after the battery
pack has been removed or other power units have
been disconnected.
●
Mould may form if the lens is left dirty.
