36
Using the MAKE/TRIG. system
The RS-485 IN terminal is configured as follows. You can assign the functions to each pin terminal by setting “REMOTE
SYSTEM” (see “PORT F1 – PORT F5” on page 27).
To assign the functions to the pin terminals
For the operation procedure, see page 19.
1. Select “REMOTE SYSTEM” on the set-up menu.
2. Set “CNT. RJ45 IN” to “SET.”
3. Select a pin name (“PORT F1” – “PORT F5”) which you want to assign a function, and then select the function you
want to assign.
• For functions which can be assigned, see the table below.
Functions controlled by MAKE/TRIG. system
Display
Functions to be controlled
Opening
Short-circuiting
INP. A
Changes the input to Input A.
Invalid
Valid
INP. B
Changes the input to Input B.
Invalid
Valid
INP. C
Changes the input to Input C.
Invalid
Valid
INP. D
Changes the input to Input D.
Invalid
Valid
INP. E
Changes the input to Input E.
Invalid
Valid
INP. F
Changes the input to Input F.
Invalid
Valid
POWER
Turns on/off the monitor.
Power on
Power off
ASPECT
Changes the aspect ratio.
REGULAR
FULL
MUTING
Turns off or resumes the volume.
Muting off
Muting on
PIP
Turns on/off the PIP mode (see page 18).
Invalid
Valid
PBP
Turns on/off the PBP mode (see page 18).
Invalid
Valid
– – –
No function
—
—
NOTE
• You cannot assign the same function to different pin terminals.
• The TRIG. (trigger) system switches each function by short-circuiting for approx. 1 second.
How to Use External Control
(cont.)
This is a female
terminal.
Pin No.
Pin name
1
PORT F1
2
PORT F2
3
PORT F3
4
PORT F4
5
PORT F5
6
ENABLE
7
NC
8
GND
06-42_GM-H40L2A-f.indd 36
06-42_GM-H40L2A-f.indd 36
06.4.24 5:21:12 PM
06.4.24 5:21:12 PM
