2
Connecting the external amplifier or subwoofer
A
Typical connections
Before connecting:
Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
ELECTRICAL CONNECTIONS
B
You can connect amplifier to upgrade your car stereo system.
•
Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
•
Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Remote lead (blue with white stripe)
To the remote lead of other
equipment or automatic
antenna if any
Front speakers
Set “L/O MODE” to
“WOOFER” (See page 14
of the INSTRUCTIONS.)
Subwoofer
Rear speakers
or
Y-connector (not supplied for this unit)
*
1
Not supplied for this unit.
*
2
Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
Line out (see diagram )
Rear ground terminal
iPod jack (see diagram
)
15 A fuse
Antenna connector
Blue with white stripe
To the remote lead of other equipment (200 mA max.)
Orange with white stripe
To car light control switch
JVC Amplifier
Set “L/O MODE” to
“REAR” (See page 14 of the
INSTRUCTIONS.)
C
Connecting an Apple iPod
Connection cable for iPod (supplied)
Apple iPod (separately purchased)
You can connect an iPod to this unit using the supplied connection cable for iPod.
Fasten the connection cable for iPod tightly across the loop using the supplied cable tie to hold the connection
cable in place.
iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
Black
Red
Yellow
*
2
Ignition switch
Fuse block
Purple
Purple with black stripe
Green
Green with black stripe
Gray
Gray with black stripe
White
White with black stripe
Right speaker (rear)
Left speaker (rear)
Right speaker (front)
Left speaker (front)
Blue
To the automatic antenna if any (250 mA max.)
Loop (see diagram
)
Cable tie
Loop
JVC Amplifier
*
3
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint
(if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
*
4
Remote lead
*
5
Signal cord (not supplied for this unit).
Install1_KD-PDR54_002A_f.indd 2
Install1_KD-PDR54_002A_f.indd 2
11/29/06 4:03:20 PM
11/29/06 4:03:20 PM
Содержание GET0425-001A
