JVC GD-V422U, Инструкция по эксплуатации

Страница: 9 / 76

9
1 2
SERIAL PC IN
AUDIO
SLOT1
S VIDEO IN
VIDEO IN VD HD P
R
/C
R
/R P
B
/C
B
/B Y/G
COMPONENT/RGB IN
AV
SLOT2 SLOT3
R AUDIO L
IN
R AUDIO L
VIDEO OUT
1
2
1
2
Connections
SPEAKERS
Terminals (R)
SPEAKERS
Terminals (L)
– Cable fixing bands Secure any excess cables with bands as required.
When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker’s Installation Manual for details on speaker installation.
Speakers (Optional accessories)
Pass the attached
cable fixing band
through the clip as
shown in the figure.
To secure cables connected to Terminals, wrap the cable fixing band
around them then pass the pointed end through the locking block, as
shown in the figure.
While ensuring there is sufficient slack in cables to minimize stress
(especially in the power cord), firmly bind all cables with the
supplied fixing band.
From SERIAL
Terminal on Computer
(see page 11) From EXTERNAL
monitor terminal on
Computer (see page 10)
AC cord connection (see page 13)
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN
and Audio IN Terminals
(see page12)
AV Terminals
(see page12)
To tighten:
To loosen:
Pull
Pull
Push the
catch
3. Slide up the clamper and fix
the AC cord plug securely.
2. Insert the AC cord and
close the clamper
securely.
1. Open the clamper.
Clamper
AC cord
Note: The power plug in the illustration may not be the type fitted to your set.
When loosen
the clamper:
Notes: (1) At factory shipment, Video Input Cards are installed in SLOT 2 and SLOT 3.
(2) Insert the optional Video Input Cards before combining the Plasma Display with the Stand Unit.
– AC cord fixing
(Example: GD-V422U)