JVC FS-J50, Инструкция по эксплуатации

Страница: 22 / 32

19
Playing Back Tapes
You can play back type I tapes.
Playing Back a Tape
1
Press PUSH OPEN
0
on the unit.
2
Put a cassette in with the exposed part of
the tape down.
3
Press PUSH OPEN
0
again to close the
cassette holder.
4
Press TAPE
2 3
.
The unit automatically turns on and the
tape starts playing. The tape direction
indicator (
3
or
2
) flashes slowly on the
display.
• Each time you press the button, the tape direction
changes:
3
: plays the front side.
2
: plays the reverse side.
When the tape plays to the end, the deck automatically
stops if the Reverse Mode is set to
or . (See
“To play both sides—Reverse Mode.”)
If no cassette is inserted when you press TAPE
2 3
“NO TAPE” appears on the display.
To stop playing, press
7
.
To fast-wind to the left or to the
right,
press
¢
or
4
while the
tape is not running.
The tape direction indicator (
3
or
2
)
starts flashing rapidly on the display.
To remove the cassette, press PUSH OPEN
0
on the unit.
• If the tape is playing, stop it first.
To play both sides—Reverse Mode
You can set the deck to play just one side of a tape, both sides
once, or both sides continuously.
Press REV.MODE (reverse mode).
• Each time you press the button, the Reverse
Mode changes as follows:
: The deck automatically stops after playing both
sides of the tape. Stops when playback in the
2
direction is finished.
: The deck continues to play both sides of the tape
until
7
is pressed.
: The deck automatically stops after playing one
side of the tape.
• DO NOT open the cassette holder when the tape
is running.
• The use of C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch-
rollers and the capstans.
REV.
MODE
PUSH OPEN
TAPE
EN16-19_UX-J60&50[B]f.pm6 02.12.23, 9:34 AM 19