JVC DR-M10S, Инструкция по эксплуатации, Страница: 102 / 116

Filename [DR-M10SE_11Subsidiary.fm]
Masterpage:Left+
102
EN
Page 102 February 12, 2004 5:31 pm
SUBSIDIARY SETTINGS (cont.)
Set Stations (B)
Set station names other than the ones registered in your unit.
A
Select the character for station name.
A Press
rt
to select “ID”, then press ENTER .
B Press ENTER twice.
B
Enter the new character.
A Press
w e
to locate the character insertion point.
B Press
rt
to cycle through the characters (A–Z, 0–9,
–,
f
, +,
I
(space)) and stop when the desired
character is indicated, then press
e
to enter.
C Enter the remaining characters the same way
(maximum of 4).
D After entering all characters, press
w e
to select “OK”,
then press ENTER .
C
Close the Confirmation screen.
Press SET UP twice.
NOTE:
The characters available for the station name (ID) are A–Z, 0–9, –
,
f
, +,
I
(space) (maximum of 4).
Fine-Tuning Channels Already Stored
A
Select the channel to fine-tune.
A Press
rt w e
to select the channel you want to fine-
tune, then press ENTER .
B Press ENTER twice.
B
Access the Manual Channel Set screen.
Press ENTER . The Manual Channel Set screen appears.
C
Perform fine-tuning.
A Press
rt
to select “FINE”.
B Press
w e
until the picture appears in its best quality.
●
Repeat steps
A
–
C
as necessary.
D
Close the Confirmation screen.
Press SET UP three times.
Perform steps
A
and
B
of “Manual Channel Set” on page 99
to access the Confirmation screen and then perform steps
A
and
B
of “Set Stations (A)” (
墌
pg. 101) before continuing.
Perform steps
A
and
B
of “Manual Channel Set” on page 99
to access the Confirmation screen before continuing.
DR-M10SE_01.book Page 102 Thursday, February 12, 2004 9:08 PM