JVC DM-NE300E, Инструкция по эксплуатации

Страница: 11 / 36

5
䡵
Rear Panel
$
[AUDIO IN] Input Terminals
Analog audio input terminals.
Disabled when DV IN terminal is used.
%
[VIDEO IN] Terminal
Video (Composite) input terminal. Set the
*
[VIDEO
SELECT] Switch at the center when using this as
the input terminal.
^
[Y/C IN] Terminal
Video (Y/C) input terminal. Set the
*
[VIDEO SE-
LECT] Switch at the lower end when using this as
the input terminal.
&
[DV IN] Terminal
DV input terminal. Set the
*
[VIDEO SELECT]
Switch at the upper end when using this as the input
terminal.
*
[VIDEO SELECT] Switch
To select either DV, Composite or Y/C as video in-
put. Set to [DV IN], [VIDEO IN] or [Y/C IN] accord-
ingly depending on the signal to be used.
Turn ‘OFF’ the power of this equipment when oper-
ating this switch.
(
[MAINTENANCE] Switch
This terminal is used only for servicing purposes.
)
[SERIAL]
Serial terminal for controlling external device.
⁄
[RS232C/RS422] Selector Switch
This switch sets the signal format of
)
[SERIAL] to
either RS232C or RS422.
Turn ‘OFF’ the power of this equipment when oper-
ating this switch.
¤
[LINK] LED
Lights up when this equipment is connected to a
network.
‹
[100BASE-TX] Terminal
100BASE-TX terminal. Output terminal for MPEG-2
stream.
›
[RXD] LED
Lights up when this equipment receives packet via
100BASE-TX.
fi
AC IN
AC 220 V~240 V inlet. Ensure to use the power cord
supplied for connection.
Make sure to earth the equipment. Do so before in-
serting the plug to the power source. When remov-
ing the earth, do so after unplugging from the power
source.
fl
Fastener
Plug in the supplied power cable, and fasten using
the fastener.
‡
Vent Outlet
(
⁄
)
*
¤
‹
›
‡
fl
fi
^
%
$
#
&
AC IN
AUDIO IN
Y/C IN
VIDEO IN
100BASE-TX
MAINTENANCE
SERIAL
RESET
RS422
RS232C
L
R
VIDEO SELECT DV IN
●
Set up this equipment near a power point.
●
Unplug the equipment from the power point or re-
move power cord from the AC inlet (AC IN) of this
equipment to cut off power completely.
Fasten by attaching the switch plates supplied after
setting items
*
and
⁄
.
This shall be performed by the sales outlet at which
this equipment is purchased.
#
[RESET] Switch
Use a pointed object to depress button.
This equipment will be reset.