JVC D402B - AV Receiver, Инструкция по эксплуатации

Страница: 28 / 52

26
Setting the Audio delay level
—AUDIO DELAY
Synchronization between audio and video reproduction can be
possibly disturbed because video signal decoding is time-
consuming compared to the audio signal decoding.
On this setting, you can correct synchronization between video
and audio signals by delaying the audio signal timing.
Adjustable range: OFF and 10 ms to 100 ms (in 10 ms intervals)
Initial setting: ADELAY OFF
>
Memorizing the volume level for each
source—ONE TOUCH OP
This receiver memorizes some settings separately for each
source. In addition, you can store the volume level for each source
with the other memorized settings (see page 17).
• This receiver memorizes the volume level
– when you turn off the power, and
– when you change the source.
ONE TOUCH
<
ON
>
Select to store the volume level separately for each
source. (The ONE TOUCH OPERATION indicator lights
up on the display.)
ONE TOUCH
<
OFF
>
Select this not to store the volume level.
Initial setting: ONE TOUCH
<
OFF
>
To recall the volume level
With the ONE TOUCH OPERATION indicator lit, the volume level
for the currently selected source is recalled when the source is
selected.
To cancel the One Touch Operation
Set One Touch Operation to “ONE TOUCH
<
OFF
>
” so that the
ONE TOUCH OPERATION indicator goes off from the display.
Selecting the source for HDMI
terminal and COMPONENT VIDEO
jacks—HDMI SELECT/CMPNT SELECT
When you connect a VCR or DBS to the “VCR (DBS) IN” terminal
in HDMI terminal or COMPONENT VIDEO jacks on the rear of the
receiver, you need to select either “VCR” or “DBS” according to
the component you connect.
If you have not selected appropriate source, you cannot view the
playback picture on the TV.
For the HDMI terminal:
HDMI
<
VCR
>
Select this when assigning the HDMI
terminal for a VCR.
HDMI
<
DBS
>
Select this when assigning the HDMI
terminal for a DBS.
Initial setting: HDMI
<
VCR
>
For the COMPONENT VIDEO jacks:
CMPNT
<
VCR
>
Select this when assigning the
COMPONENT VIDEO jacks for a VCR.
CMPNT
<
DBS
>
Select this when assigning the
COMPONENT VIDEO jacks for a DBS.
Initial setting: CMPNT
<
VCR
>
Selecting the output video signals
—VIDEO OUTPUT
When you connect your TV and this receiver with the HDMI cable,
set this setting to “VIDEO
<
HDMI
>
.”
With this setting, this receiver converts incoming composite video,
S-video, and component video signals from video components
and transmits the converted signals through the HDMI cable.
VIDEO
<
HDMI
>
Select this when connecting a TV to the HDMI terminal.
VIDEO
<
OTHER
>
Select this when connecting a TV with a video jack(s)
other than the HDMI terminal.
Initial setting: VIDEO
<
HDMI
>
NOTE
When selecting “VIDEO
<
HDMI
>
,” the AV COMPU LINK remote
control system (see page 38) may not operate properly. In this
case, do not make the AV COMPU LINK connection.
20-26RX-D401S[J]_f.p65 05.7.1, 7:07 PM 26