– 8 –
English
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
Using a screw driver, set the voltage selector so that the arrow
on printed on the rear points the correct voltage where you
use this unit. (See the back cover page.)
To audio output
NOW, you can plug in the unit and other
connected equipment FINALLY!
Cancelling the Display Demonstration
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press
DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing DEMO.
To start the display demonstration manually
Press and hold DEMO again for more than
2 seconds.
AUX IN
Audio equipment
Connecting Other Equipment
You can connect an audio equipment.
• DO NOT connect any equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
CANCEL
/DEMO
CANCEL
/DEMO
220
127
11
0
VOLTAGE
SETTING
230-
240
220
VOLTAGE
SETTING
127
240
11
0
230-
EN01-12.MX-K5[US],[UW]_f
01.4.6, 10:00 AM
8
