JVC CA-FSXA1, Руководство по обслуживанию

Страница: 24 / 65

1-24 (No.MB546)
SECTION 4
ADJUSTMENT
*ATTENTION IN SERVICE OF DVD SECTION
(1) When pickup, flash rom, DVD module board were changed, initialize EEPROM all means.
(2) When full initialization was executed, execute learning with a DVD test disc by all means.
Test disc : VT-501, VT-502
Learning method : It is adjusted automatically by normal playback of a DVD disc.
4.1 Test mode 1
4.2 Test mode 2
4.2.1 To enter DVD TEST mode
Item Operation Management
TUNER AM switch to
9kHz-step AM frequency change to 9kHz at U & A-version. |<< [key] + POWER button
(Only source TUNER AM)
TUNER AM switch to
10kHz-step AM frequency change to 10kHz at U & A-version. >>| [key] + POWER button
( Only source TUNER AM)
Cold start Cold start processing. STOP+'0'+AUDIO POWER (REMOCON)
Clock Fast Forward Make the clock fast forward. STOP+'2'+AUDIO POWER (REMOCON)
Volume change Make the volume from the min to max. STOP+'3'+AUDIO POWER (REMOCON)
Micon Version check Check the micon version. STOP+'9'+AUDIO POWER (REMOCON)
LCD all display All of the icons on the FL are lightened. STOP+'10'+AUDIO POWER (REMOCON)
Tray lock Loader-mecha is locked.
EJECT processing isn't done by pushing EJECT key
at tray lock on state.
Then display to LOCKED / UNLOCKED.
EJECT is pushed , pushing STOP again , tray lock is off.
Back up to tray locked ON/OFF. EJECT is pushed ,
during pushing STOP at STAND-BY
DVD test mode In to the DVD test mode. Test mode contents is refer to
module spec.
DVD test mode is canceled by POWER OFF and except
source DVD. AC input pushing PLAY + PAUSE [key]
DVD initialize DVD module initialized.
FL segment is light on at initialize completed. 3D PHONIC [key] during DVD test mode
DVD region confirm
mode Into the DVD region confirm mode.
Display region code on FL. AC input pushing B.SKIP I<< +
DVD/CD [key]
compulsion NTSC
mode Into the compulsive NTSC mode.
Hereafter , only first power-on , start by NTSC unrelated
NTSEL-SW. ( Send command to module )
Mode is clear at POWER OFF. AC input pushing STOP + DVD/CD [key]
DVD region confirm
mode Into the DVD region confirm mode.
* DVD REGION CHECK CAN ONLY BEEN DISPLAY
DURING SYSTEM POWER ON IN DVD MODE
(WHEN DVD LSI P.ON).
Temporary display region code on FL for 5 seconds.
FL will display "REGION x" where x is the Region
number.
* IF THERE IS NO INFORMATION FEEDBACK,
SYS-CON WILL DISPLAY
"WAIT" BLINKING 0.5SEC ON & OFF.
* FL WILL DISPLAY "AREAxxRy" WHERE "AREAxx" is
the DESTINATION INFO & R is the REGION INFO
After 5 seconds, return to previous display. AC input pushing B.SKIP I<< +
DVD/CD [key]
(1) AC POWER OFF.
(2) Press and hold PLAY + PAUSE keys.
(3) AC POWER ON while holding PLAY + PAUSE keys.
(4) DVD Mecha will start in TEST MODE, FL will display:
T x x y v w
xx is the received DESTINATION information. Display as follows:
xx = JC/1U/D/E/2U/3U/UB/UT/4U/UY/EE/UF
y = region number
v = study state information from DVD UNIT
w = initialization state from DVD UNIT