(No.MB666<Rev.005>)1-27
3.2.14 Removing the sensor board and SV resistor
(See Fig.33)
• Remove the tray assemblies, side (L), side (R) assembly and
lifter assembly.
(1) Remove the solders from the soldered sections
aj
on the
sensor board and remove the wires.
(2) Remove the two screws
Q
and take out the sensor board
with the SV resistor.
Reference:
• Remove the soldered section
ap
on the sensor board as re-
quired.
• When reassembling, pass the wires through the slot
ak
of
the sensor board as before.
Note:
When reattaching the SV. resister, fit the projection am on the
bottom of the SV. resister into slot
an
of the sensor slider.
Fig.33
3.2.15 Taking out the disc in the play mode
(See Fig.34 to 37)
Reference:
Refer to "Removing the tray assemblies".
(1) From the top side of the DVD changer mechanism assem-
bly, remove the top cover.
(2) Unlock the tray assemblies and draw out the tray assem-
blies toward the front.
(3) From the top side of the DVD changer mechanism assem-
bly, turn the gear 1 clockwise to move the lifter assembly
upward. (See Fig.34.)
(4) Turn the gear 2 clockwise to move the sub tray remaining
inside the lifter assembly toward the front, then pull out.
(See Fig.34.)
(5) Take out the disc on the sub tray. (See Fig.35.)
(6) After clearing away the disc, insert the sub tray into the
main tray. (See Fig.36.)
Note:
When reattaching the sub tray, move the tray stopper on
the bottom of the main tray in the direction of the arrow
to lock the sub tray certainly. (See Figs.36 and 37.)
(7) Push the tray assembly toward the DVD changer mecha-
nism assembly and reattach.
Fig.34
Q
Q
ap
Sensor board
ak
SV resistor
am
an
SV resistor
Slider
aj
Sub tray
Gear 1
Tray assembly
Gear 2
