30
English
Care And Maintenance
Compact Discs
Handle your compact discs, cassette tapes, and
Cassette Deck carefully, and they will last a
long time.
•
Remove the CD from the case by holding
it at the edges while pressing the centre
hole lightly.
•
Do not touch the shiny surface of the CD,
or bend the CD.
•
Put the CD back in its case after use to
prevent warping.
•
Be careful not to scratch the surface of the
CD when placing it back in the case.
•
Avoid exposure to direct sunlight,
temperature extremes, and moisture.
•
A dirty CD may not play correctly. If a CD
does become dirty, wipe it with a soft cloth
in a straight line from centre to edge.
CAUTION: Do not use any solvent (for exam-
ple, conventional record cleaner, spray thin-
ner, benzine, etc.) to clean a CD.
Moisture Condensation
Moisture may condense on the lens inside
the Unit in the following cases:
•
After starting the heating in the room.
•
In a damp room.
•
If the Unit is brought directly from a
cold to a warm place.
Should this occur, the Unit may malfunc-
tion. In this case, leave the Unit turned on
for a few hours until the moisture evapo-
rates, unplug the AC power cord, and then
plug it in again.
General Notes
In general, you will have the best performance by keeping your
tapes, CDs, and the mechanism clean.
•
Store tapes and CDs in their cases, and keep them in cabinets
or on shelves.
•
Keep the Cassette Deck’s tape doors and the CD trays closed
when not in use.
Cassette Tapes
•
If the tape is loose in its cassette, take
up the slack by inserting a pencil in
one of the reels and rotating.
•
If the tape is loose, it may get
stretched, cut, or caught in the cassette.
•
Do not touch the tape surface.
•
Do not store the tape:
-
In dusty places
-
In direct sunlight or heat
-
In moist areas
-
On a TV or speaker
-
Near a magnet
Cassette Deck
•
If the heads, capstans, and pinch-rollers of the Cassette Deck
become dirty, the following will occur:
-
Loss of sound quality
-
Discontinuous sound
-
Fading
-
Incomplete erasure
-
Difficulty recording
•
Clean the heads, capstans, and pinch-rollers using a cotton
swab moistened with alcohol.
•
If the heads become magnetized, the Unit will produce noise
or lose high frequencies.
•
To demagnetize the heads, turn off the Unit, and use a head
demagnetizer (available at electronics and record shops).
Pinch-rollers
Capstans
Heads
CA-D302/352TR[E]/EN
98.2.13, 9:57 PM
30
