(No.52172)1-5
SECTION 3
DISASSEMBLY
3.1
DISASSEMBLY PROCEDURE
3.1.1 REMOVING THE REAR COVER
(1) Unplug the power cord.
(2) Remove the 6 screws
[A]
as shown in the figure.
(3) Withdraw the REAR COVER toward you.
3.1.2 REMOVING THE MAIN PWB
• Remove the REAR COVER.
(1) Slightly raise the both sides of the chassis by hand and
Withdraw the CHASSIS backward.
(If necessary, take off the wire clamp, connectors etc.)
3.1.3 REMOVING THE SIDE SPEAKER
• Remove the REAR COVER.
(1) Remove the 2 screws
[B]
, attaching the SPEAKER.
(2) Follow the same steps when removing the other hand
SPEAKER.
3.1.4 CHECKING THE PW BOARD
• To check the back side of the PW Board.
(1) Pull out the CHASSIS. (Refer to REMOVING THE
CHASSIS).
(2) Erect the CHASSIS vertically so that you can easily check
the back side of the PW Board.
CAUTION:
• When erecting the CHASSIS, be careful so that there will be
no contacting with other PW Board.
• Before turning on power, make sure that the wire connector
is properly connected.
• When conducting a check with power supplied, be sure to
confirm that the CRT EARTH WIRE (BRAIDED ASS’Y) is
connected to the CRT SOCKET PW board.
3.1.5 WIRE CLAMPING AND CABLE TYING
(1) Be sure to clamp the wire.
(2) Never remove the cable tie used for tying the wires
together.
Should it be inadvertently removed, be sure to tie the wires
with a new cable tie.
FBT
MAIN PWB
SPEAKER
CRT SOCKET PWB
TUNER
POWER CORD
POWER SW
FRONT CABINET
A
B
