JVC AV-20NX3, Руководство по обслуживанию

Страница: 14 / 39

14 No. 52079
AV-20NX3
SERVICE ADJUSTMENTS
ADJUSTMENT PREPARATION
1. You can make the necessary adjustments for this unit with either the remote control unit or with the adjustment equipment and parts
as given below.
2. Adjustment with the remote control unit is made on the basis of the initial setting values, however, the new setting values which set the
screen to its optimum condition may differ from the initial settings.
3. Make sure that AC power is turned on correctly.
4. Turn on the power for the set and test equipment before use, and start the adjustment procedures after waiting at least 30 minutes.
5. Unless otherwise specified, prepare the most suitable reception or input signal for adjustment.
6. Never touch any adjustment parts, which are not specified in the list for this adjustment-variable resistors, transformers, capacitors, etc.
7. Presetting before adjustment.
Unless otherwise specified in the adjustment instructions, preset the following functions with the remote control unit.
Setting item Setting value
PICTURE MODE(VSM) BRIGHT
VNR OFF
BASS, TREBLE, BALANCE CENTRE
TINT, COLOUR, BRIGHT, SHARP CENTRE
CONTRAST MAXIMUM
MEASURING INSTRUMENT
1. DC voltmeter (or Digital voltmeter)
2. Oscilloscope
3. Signal generator (Pattern generator) [PAL/SECAM/NTSC]
4. Remote control unit
ADJUSTMENT ITEMS
•
B1 POWER SUPPLY
•
FOCUS ADJUSTMENT
•
IF CIRCUIT ADJUSTMENTS
Adjustment of VCO (CW)
Adjustment of DELAY POINT (AGC TAKE-OVER)
•
VC (VIDEO/CHROMA) CIRCUIT ADJUSTMENTS
Adjustment of WHITE BALANCE (Low light)
Adjustment of WHITE BALANCE (High light)
Adjustment of SUB BRIGHT
Adjustment of SUB CONTRAST
Adjustment of SUB COLOUR-
ΙΙΙΙΙ
Adjustment of SUB COLOUR- ΙΙ ΙΙ ΙΙ ΙΙ ΙΙ
Adjustment of SUB TINT-
ΙΙΙΙΙ
Adjustment of SUB TINT- ΙΙ ΙΙ ΙΙ ΙΙ ΙΙ
•
User mode setting position
•
DEFLECTION CIRCUIT ADJUSTMENTS
Adjustment of V. SLOPE
Adjustment of V. POSITION
Adjustment of V. HEIGHT
Adjustment of H. POSITION
Adjustment of H. WIDTH
Adjustment of SIDE PIN
Adjustment of TRAPEZIUM
Adjustment of V. S-CURVE
Adjustment of CORNER
Adjustment of H. PARALLEL
Adjustment of H. BOW
•
VSM PRESET SETTING
•
PRESET SETTING
•
PURITY ADJUSTMENT
•
CONVERGENCE ADJUSTMENTS
Adjustment of STATIC CONVERGENCE
Adjustment of DYNAMIC CONVERGENCE