JVA ZLM4, Техническое руководство

Страница: 27 / 32

© JVA Technologies Pty Ltd
Page 27 of 32 Issue:3/03/2021 9:39:00 AM
OEM technical manual.docx
Gate Delay (13x#)
The gate switch must remain open for longer than the
Gate Entry/Exit
Delay
before the Gate Alarm is triggered. If the switch closes within this
time, the Gate timer is reset to the
Gate Entry/Exit Delay
value.
Chime mode (14x#)
This option allows the ZLM4 internal beeper and the keypad beeper to be used
as a door chime for the gate switch.
When set to
None , the keypad beeper is used to indicate correct keypad
operation only.
When set to
Door Chime , the beepers will sound when the gate switch opens,
even
if the energiser is disarmed. Note “Gate” must be selected in Input 2
Function
(Option 12).
If set to Siren, the beepers mimic the siren function.
Gate Beeps plus Siren will give 2 beeps on Gate open and 4 on close, plus
continuous for an alarm. Beeps are on Keypad only, not internal beeper.
Fence Mode (15x#)
Not currently implemented, for future use.
Binary Options (16x#)
Each option in this table can be turned on by adding the value.
For 1 set 16 to 01, for + 1 and +2 set 16 to 03.
+1: Enable Siren Acknowledge. The siren will chirp once for armed and
twice for disarmed.
+2 Enable Siren Acknowledge. The siren will chirp once for armed and
twice for disarmed.
+4 Enable to stop bad battery alarms if you are not using a battery (Added
in version 1.2)
+8 Disable Cross Couple Alarms [see section 3.1] (added in version 1.33)
Zones (not yet implemented)
This Option sets the amount of Zones the ZLM4 will monitor. This will reduce the
amount of unnecessary information that will be displayed if you are only
monitoring one zone.
Value Time
0 0 Seconds
(immediate)
1 30 Seconds
2 1 Minute
3 2 Minutes
4 3 Minutes
5 4 Minutes
6 5 Minutes
7 6 Minutes
8 7 Minutes
9 8 Minutes
Value Function
0 None
1 Door Chime
2 Siren
3 Fence Alarm
4 Gate beeps
plus Siren
Value Function
0 None
+1 Disable prox
switch
+2 Siren codes
+4 No battery
+8
(default) Disable Cross
Couple Alarm
Value Function
0 None
1 One Zone
2 Two Zones
3 Three Zones
4 Four Zones