Shenzhen Just Motion Control Electro-mechanics Co., Ltd
0755-26509689
- 12 -
Remark:
a. t1: ENA must be ahead of DIR by at least 5
μ
s. Usually, ENA+ and
ENA- are NC (not connected).
b. t2: DIR must be ahead of PUL active edge by 6
μ
s to ensure correct
direction;
c. t3: Pulse width not less than 2.5
μ
s;
d. t4: Low level width not less than 2.5
μ
s.
6. DIP Switch Setting
6.1 Micro steps Setting
The micro steps setting is in the following table,
while SW1
、
SW2
、
SW3
、
SW4 are all on, the internal default micro steps inside is
