jurop RV360, Инструкция по установке, использованию и техническому обслуживанию

Страница: 18 / 32

I
NSTALLATION
,
USE AND MAINTENANCE MANUAL
– RV360 - 520
R
EV
. 09
21-03-2016
18 / 32
Jurop
SpA
Via Crosera n° 50
33082 Azzano Decimo, PN (Italia)
T
EL
. +39 0434 636811 F
AX
. +39 0434 636812
http://www.jurop.it
e-mail: info@jurop.it
-
+
• Reassemble the parts in the following sequence:
- Vacuum pump flange: do not damage the seal while inserting it
on to the axis. Correctly centre and fasten the screws. Properly
align the bearing into its seat.
- Front seal cap: do not damage the seal while inserting it on to the
axis and fasten the screws.
- Fan with docking set.
-
Respect the correct distance from the axis head.
- Fasten the 4 screws of the docking set with 10 Nm coupling.
Reassembly the conveyors and their protection.
Do not damage components during assembly by
forcing them exceedingly.
Pic. 6.10
• Do not flip the seal ring during rotation of the shaft. Do not leave
foreign objects inside the pump.
Mounting the hydraulic drive
• We recommend the drive coupling be oiled when vanes are being
replaced. See Pic. 6.11.
• However lubricate the drive coupling every 1500 hours.
We recommend the drive coupling be oiled every
1500 hours.
• Apply coupling hub (H1) to vacuum pump axis respecting the
position marked during disassembly: the grain must go back into the
seat on the rim.
RV 360
RV 520
Pic. 6.11
• Mount the coupling (H1) and lubricate internally with NLGI 2
Lithium grease. Provide an adequate quantity of fat, in order to have a
medium filling.
• Reassembly the motor without forcing onto the seals (H9).
Adjusting the self-lubricating pump
• The automatic lubricating pump is adjusted by the manufacturer
before the shipping.
• If consumption noticeably differs from the indicated value, adjust it
as follows:
-
Remove the upper protection cover;
-
Using a screwdriver and a 10 mm wrench, adjust the adjusting
screw (K). Close the nut and remount the upper protection cover;
-
It is advisable to turn the screw of ¼ of turn and verify the actual
consumption.
Pic. 6.12
Do not reduce oil consumption below the value
indicated in par. 2.3 (for functioning at speeds
different from the maximum, flow is proportionate
to rotating speed).
• ½ turn of the adjusting screw causes a variation in the flow of
approximately 40 - 80 g/h , depending on using conditions.
1/2 giro
40 - 80 g/h
K
½ giro
40 – 80 g/h