wiJAC2-002
Wireless Intercom System - Wireless Dropcord - N America
Operating Manual
Rev A
Page 15
If another aircraft system is experiencing a fault, turn off and remove the JB60-002 Headset Adapter and the
JB69-002 Intercom Adapter and connect the headset directly to the audio panel. Do not use the JB60-002 Headset
Adapter and the JB69-002 Intercom Adapter if they appear to be the cause of the fault.
4.1.8
Battery Life
The operating duration of the
wiJAC2
-002 system with fully charged batteries before battery replacement is required
depends on the following factors:
•
Distance between Headset Adapter and Intercom Adapter:
The closer together the units are the lower the radio frequency (RF) power required for connection. This will
increase the battery life.
•
Obstacles between the Headset Adapter and Intercom Adapter (VOL):
Minimising the aircraft metal structures, human bodies, cargo and other obstacles between the units will reduce
the RF power needed for connection and increase the battery life.
•
Charge capacity of the batteries installed:
The higher the capacity of the batteries, typically specified as 2000 to 2400 mAh (milliamp-hours), the longer the
battery life.
•
The type of batteries installed and the operating temperature:
During low temperature operation, rechargeable batteries will lose capacity. When operating in low temperatures
use alkaline batteries for a longer battery life.
•
The phones volume level and usage rate:
The lower the volume level and the less often audio is output to the phones, the longer the battery life.
5
Compliance Statements
5.1
FCC compliance statement
This device complies with Part ·15 of the FCC Rules for only portable part.
Contains transmitter module IC: 9576A-SC14S.Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation of
the device.
Module transmetteur ID IC: 9576A-SC14S. Son fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas causer d'interférences nuisibles et
(2) appareille doit accepter toute int
e
rférence reçue y compris les interférences peuvent perturber le fonctionnement.
5.2
Industry Canada compliance statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNH d'lndustrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
