JA98-001 Remote Mount Audio Controller
Installation and Operating Manual
Rev A
Page 8
f) Plug in any remaining headsets, and check for correct ICS operation. Note that an incorrect cordset (drop cord)
or improper jack wiring may cause a wide range of problems, from loss of audio to a tone heard in the headset.
g) Check that all configuration settings are correct.
When all performance checks are satisfied, complete the necessary regulatory documentation before releasing the
aircraft for service. Refer to
Appendix B.
2.5
Adjustments and Configuration using ProCS™
The JA98-001 configuration adjustments are set from the configuration program ProCS™. Configuration data is sent to
the JA98-001 via the configuration connector (J3), using the configuration program and JA99-001 Configuration Cable.
Refer to the
ProCS manual
for complete information on the configuration process.
2.5.1
JA98-001 ProCS Connection
2.5.2
Configurable Settings
A standard unit is shipped from the factory with all internal adjustments configured to the default levels. At installation,
it may be desirable to change some of these settings to suit the local operating environment.
Within ProCS™, the configurable settings are grouped together into the following sections:
Note:
It is important to be aware that some of the screens shown may appear slightly differently,
depending on whether or not a JA98-001 is connected.
Selecting COM ports:
The JA98-001 requires connection to two COM ports. The COM ports
are
select
ed from
Edit > Options
in
the main ProCS menu. The
Application Options window will open.
The designated Product
C
onfiguration COM Port confirmed during
ProCS installation (see ProCS Installation and Operation Manual
section 2.4.2) can be
selected
through this window.
The Product Control COM Port is also se
t
from this window.
