JA95-N11 Audio Controller - RX Mute - NVG
Installation and Operating Manual
Rev A
Page 18
(5)
Multi-function (Transmit/ICS) Switch
This is a green two-position centre-off momentary toggle
switch.
When in the default XMIT/ICS configuration, this switch
acts as the pilot’s ‘Press-to-talk’ (PTT) button. The unit
will transmit on the selected transceiver when the switch
is held in the ‘up’ position, and when held in the ‘down’
position, it will transmit on the intercom.
See
section 3.3.7
below for Multi-function Switch operation.
Note
: At installation, this switch may be configured to operate in default or alternative mode. Check with
your installing agency for confirmation of the operation of this switch. The legends are interchangeable to
allow customization.
(6)
Music/Configuration Connector (
♫/io)
This is a music input that is compatible with most music players.
It accepts a 3 pole 3.5mm stereo plug with a slim diameter
connector housing.
(This connector is also used during installation to change
configuration settings.)
CAUTION
:
If an unapproved connector or cable is used, damage to the unit or to any attached device may
occur. If in doubt, contact JAC for a list of approved cables, music sources and devices.
(7)
Transmit Annunciator - TX
This is a deadfront annunciator that will
illuminate when the JA95-N11 is transmitting.
The default legend is ‘TX’, but it is
interchangeable to allow customization.
(8)
Transmit Selector
This is a rotary six-position control that is used to
select transmission via one of the five transceivers
or the public address system (PA).
Each of the transmit selector positions is linked by
a white line to the corresponding transmit select
annunciator, transceiver switch and legend.
The appropriate annunciator will light green to
show which transceiver is selected for transmit -
‘PA’ in this example.