pg 2 of 3
INSTALLATION INSTRUCTIONS
Surface Mount Power Units
TF6150E 12 volt, 150 watt, single output
TF6300 12 volt, 300 watt, single output
SAVE THESE INSTRUCTIONS
Flexible Feed, Using:
TF950 Flexible Feed Kit &
TF21 Electrical Feed Cylinder
Note: The Flexible Feed is not intended to
support the Trac or any weight, only to pro-
vide power to the Trac.
11. Insert tinned end of wires through holes
in top of feed cylinder and firmly tighten
terminal screws.
12. Pass wires through top cap and screw
cap onto feed cylinder.
13. Pass wires through grommet (G) in
cover. Determine cord length, leaving
some slack and tighten clamp in place.
14. Hook wire onto bracket.
15. Return to step 16 on the previous page.
Pendant Feed, Using:
TF900 Series Pendant Stem, &
TF21 Electrical Feed Cylinder
11. Thread two nuts on top of stem leaving
space between nuts. Slide top cap onto
stem. Install and tighten bushing onto
stem.
12. Cut two pieces of 10-ga. solid copper
wire to length. Strip one end of each
wire 5/8”. Tightly bind one wire under
each feed cylinder terminal screw.
13. Push wire through stem and screw top
cap onto Feed Cylinder as shown. Pass
assembly through cover.
14. Carefully bend wires at top of stem
90˚ and push assembly onto bracket.
Tighten nuts.
15. Return to step 16 on the previous page.
