Installation Instructions
Step 1.
Remove the T271L fixture from the trac and
place it face up as shown in (Figure 1).
Step 2.
Grasp the lens retaining ring as shown in
(Figure 1), away from the locking dimples.
Step 3.
Rotate the lens retaining ring about 1/8 turn
counterclockwise and remove.
Step 4.
Note the position and orientation of the part
number tab on the original lens as shown in
(Figure 2).
Step 5.
Carefully remove the original lens and replace
with the accessory lens, installing it with the
part number tab in the same orientation as the
original lens. DO NOT TOUCH EITHER FLAT
SURFACE OF THE LENS AS SCRATCHES
AND FINGERPRINTS MAY ALTER ITS
PERFORMANCE.
Step 6.
Replace the lens retaining ring, again grasping
it away from the locking dimples. Rotate the
lens retaining ring about 1/8 turn clockwise
until it clicks into place.
SAVE THESE INSTRUCTIONS
1300 South Wolf Road • Des Plaines, IL 60018
PHONE (847) 827-9880 • FAX (847) 827-2925 • www.junolightinggroup.com
© 2012 Juno Lighting LLC Printed in USA Rev 11/12 P3550 pg 1 of 2
INSTALLATION INSTRUCTIONS
Instructions for T271L Lens Replacement
WARNING:
For your safety, read and understand instructions completely before starting installation.
Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.
Note:
Use with non-Juno fixtures voids Juno warranty.
Grasp here
Grasp here
Locking dimple
To remove
Lens Retaining Ring
Figure 1
Lens
Part number tab
Figure 2
