JUNO JSI 6961 Скачать руководство пользователя страница 7

Страница: 7 / 20

The Water Softener

Water contains varying amounts of lime and mineral
salts depending on the area where you live: these are
deposited on the dishes leaving white marks.

The higher the content of these salts, the harder your
water will be. The «hardness» level is measured on 2
equivalent scales: French Degrees or German Degrees.
Contact your local Water Authority to find the exact
water hardness level for your area.

The dishwasher is equipped with a softener which us-
es special dishwasher salt to provide lime-free
(softened) water. The softener can treat water hard-
ness up to 90 french degrees via 9 adjustment levels.

Find on the table below the level corresponding to the
hardness of your water and the required adjustments:

The dishwasher is factory set level «4» as this suits most users.

To set the dishwasher to a different level, proceed as follows:

Press the ON/OFF button to turn the dishwasher on.

Then simultaneously press
the HALF LOAD button
and DELAYED START but-
ton

for approximately 5

seconds: an «L» followed
by number 4 ( the hardness
level set in the factory) will
appear on the display

Press the DELAYED START button consecutively until
the required level appears on the display.

Each time the button is pressed, you will go up one
level.

When you have not pressed the Delayed Start button
for 5 seconds, the dishwasher will set the hardness
level to that shown on the display and return to the
programme setting mode.

Salt MUST be used regularly from level «1» upward,
if you use the new compact detergent containing
enzymes.

If you use traditional detergents containing phos-
phates, you should add salt starting from level «2».

If your water is level «0» it is already soft and there-
fore there is no need to use salt.

Filling with Salt

Only use salt which is specifically designed for use in
dishwasher. Other types of salt contain high
percentages of other substances which may reduce
the efficiency of the water softener.

Unscrew the cap of the salt container.

Place approximately 1,5 ÷ 1,8 kg of dishwasher salt
inside using the funnel provided (see figure).

Replace the cap making sure that there is no trace of
salt on the screw thread or on the gasket.

Screw the cap on tightly.

When this has been done, all that is then required is
to periodically top up the container with salt. You are
reminded of this by the Salt Refill Indicator Light

the control panel which will illuminate when the salt
has finished.

The salt container has always some water inside
which will normally overflow when refilling with salt.

Important: The Salt Refill Indicator Light on the con-
trol panel can remain illuminated for 2-6 hours after
the salt has been replenished, assuring the dishwash-
er remains on. If you are using salts that take longer
to dissolve then this can take longer. The function of
the dishwasher is not affected.

Caution

Only fill with salt just before starting one of the
complete washing programmes (not the Rinse and
Hold programme). This will prevent any grains of salt or
salty water, which may have been spilled, remaining on
the bottom of the machine for any period of time.
This could cause corrosion.

PAA20GB

German degrees

(°dH)

French degrees

(°TH)

PPM

(Parts per Million)

Level

0-8

9-14

15-20
21-30
31-40
41-50
51-60
61-70
71-80
81-90

0-4
5-8