JUNO JRG 90122, Руководство пользователя

Страница: 8 / 24

Problem Possible cause Solution
The mains plug is not connected
to the mains socket correctly. Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket. Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
The compressor operates
continually. The temperature is not set cor-
rectly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently. Do not keep the door open longer
than necessary.
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
The room temperature is too
high. Decrease the room temperature.
Water flows on the rear
plate of the refrigerator.
During the automatic defrosting
process, frost defrosts on the rear
plate. This is correct.
Water flows into the re-
frigerator. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows
into the water collector. Make sure that products do not
touch the rear plate.
Water flows on the
ground. The melting water outlet does not
flow in the evaporative tray above
the compressor. Attach the melting water outlet to
the evaporative tray.
The temperature in the
appliance is too low. The temperature regulator is not
set correctly. Set a higher temperature.
The temperature in the
appliance is too high. The temperature regulator is not
set correctly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high. Let the product temperature de-
crease to room temperature before
storage.
Many products are stored at the
same time. Store less products at the same
time.
There is no cold air circulation in
the appliance. Make sure that there is cold air cir-
culation in the appliance.
Replacing the bulb
If you want to replace the bulb, do these
steps:
1. Break the circuit of the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of the
arrow.
3. Replace the bulb with one of the same
power (the maximum power is shown on
the light bulb cover)
4. Replace the light cover by sliding it into its
original position.
5. Reconnect the appliance.
6. Open the door and check if the light
comes on.
8 electrolux