15
Fig. 3
Push appliance into
housing until stop
strip (A) touches the
kitchen unit.
Fig. 4
If after having car-
ried out the operation
described in the pre-
vious section there is
still some space left
between the appli-
ance and the kitchen
unit, fit the trimming
provided together
with the appliance on
the stop strip (A).
Fig. 5
Open the door and
push the appliance
against the side of
kitchen furniture op-
posite to that of ap-
pliance hinges.
Fasten the appliance
with 4 screws pro-
vided in the kit in-
cluded with the ap-
pliance. Snap vent
grill (C) and hinge cover (D) into position.
Fig. 6
Press in the joint
covers between the
appliance and the
kitchen furniture.
Fig. 7
Apply covers (B) on
joint cover lugs and
into hinge holes.
Fig. 8
Position the runners
(H) at the top and
bottom of the inside
of the kitchen unit
as shown in Fig. 8
and mark the posi-
tion of the external
holes.
After preparing the
h o l e s , s c re w t h e
runners to the kit-
chen unit door using 3.5x16 mm screws.
Fig. 9
Open both the ap-
pliance door and
that of the kitchen
unit to approx. 90
°
.
Place the little pla-
tes over the runners.
Hold the doors of
the appliance and
t h e u n i t t o g e t h e r
and mark the holes.
Fig. 10
Remove the little
plates and make the
holes with a diam. of
2 mm. Replace the
little plates over the
runners and screw in
the screws provided
(3.5x16 mm).
For the alignment
of the kitchen unit
door, if necessary,
use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
A
D015
D265
A
D
C
D353
B
D094
20mm
H
8mm
PR34
PR35
