14
Fig. 4
Take the hinge re-
moved from the up-
per part of the appli-
ance on the opposite
side (see Fig. 4), and,
using the screws re-
moved from the lower
part, fix it to the base
of the appliance it-
self.
Remove and refit the other hinge on the upper part of
the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges (Fig. 4).
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and fit
the insert supplied with the appliance on the opposite
side.
Fitting a decorative door panel
Important: The components needed to fit the dec-
orative panel have been pre-fitted on the appli-
ance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied.
Before starting to fit the panel, remove the large
top bracket by unscrewing the screws and adjust-
ing pins pre-fitted on the appliance door. The small
bottom bracket need not be removed.
Fig. 5
Place the appliance
in the position where
it is to be built in
(Fig. 5).
The appliance is fit-
ted with adjustable
feet; screw the front
and rear feet in or out
to adjust the height
of the appliance to
that of the recess.
Keeping the appliance central in the recess, slide it in
until its back touches the wall.
With a tape measure (or similar instrument), measure
distance (A) between the top edge of the door and the
top edge of the decorative panel, placing it next to the
recess.
D510
D467
=
=
A
Fig. 6
Lay the panel face
down (Fig. 6). Posi-
tion the top bracket
on the panel, making
sure that there is an
equal distance be-
t w e e n i t a n d t h e
sides and that its dis-
tance from the top
edge is equal to dis-
tance (A) less 1 cm.
Secure the bracket with the screws supplied.
Take care not to damage the front face of the panel
whilst working.
Fig. 7
Insert the adjusting
pins (B-Fig. 7) into
their locations in the
door and screw them
in.
Fig. 8
Hook the decorative
panel onto the top
part of the door, in-
serting the pins (B)
(on the door) into the
elongated holes (1)
(in the top bracket
fitted to the panel)
(Fig. 8).
Insert the securing screws (C) through elongated
holes (2) and fix the panel without tightening the
screws (Fig. 8).
Fig. 9
Once the top of the
panel has been cor-
rectly positioned, fix
it through the holes in
the bottom bracket,
without tightening the
screws (Fig. 9).
D468
A
-1cm
=
=
D532
B
D533
1
B
2
C
D471
