8
Fixing to the cabinet - Fig. 6
a. Make four holes at the bottom of the
cabinet .
b. Remove the exhausting grid (Fig. 2).
c. Remove the screws from the container
on the side of the conveyor.
d. Fit the four 4.2x35 screws supplied, from
inside the cabinet in the holes on the
appliance.
e. Refit the exhaust grid.
Using the hood
JDU 1230 - JDU 1450
The hood is provided with a 3-speed motor.
For the best performance, we recommend
using the low speeds in normal conditions
and the high speeds in particular cases of
strong odour and vapour concentration.
JDU 1130 - SDU 1130
The hood is provided with a 1-speed motor.
— We recommend starting up the hood a
few minutes before cooking and keeping
it running until all the odours have been
eliminated.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Grease filter
The hoods JDU 1230, JDU 1130 and SDU
1130 have a thin paper grease filter; the
hood JDU 1450 has a metal grease filter.
The metal grease filter lasts forever and
must be washed at least once a month
either by hand or in the dishwasher (60°C)
with suitable detergents.
Attention! When washed in a dishwasher,
the metal grease filter may discolour.
Let the filter dry without damaging it before
putting it back into place.
This paper grease filter must be replaced
every month.
To replace the filter, proceed as follows:
a. Slide the two side latches to release the
grid (Fig. 2,2 - Fig. 2,3).
b. Remove the grid completely , pull the
right side of the grid forward and unhook
it from the slots to which it is attached
(Fig. 2,5).
c. Remove the stops of the filter (Fig. 7,1 -
Fig. 7,2).
When the filters are washed, the grid should
also be cleaned with warm water and
biodegradable detergent.
Charcoal filter
This filter dissolves cooking odours.
The charcoal filter must never be washed.
It should be changed every 4 months in
normal use.
Mounting and replacing the charcoal
filter:
a. Disconnect the hood from the electricity.
b. Remove the exhausting grid (Fig. 2).
c. Pull-out the tab (1).
d. Turn the filter in the counterclockwise
direction (2).
To mount a new charcoal filter, see the
section in the paragraph Recycling
version - Mounting the circular
charcoal filter
e. Refit the exhaust grid.
Replacing the lamp
a. Disconnect the hood from the electricity.
b. Remove the exhaust grid (Fig. 2).
c. Always replace burnt-out lamps with
40Watt max. (E14).
d. Fit again the exhaust grid.
e. Before calling for repair service because
the hood fails to light up, make sure the
bulbs are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents.
Never use products containing abrasive.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.