JUNO 942 051 295, Руководство пользователя

Страница: 53 / 260

•
Before carrying out any maintenance, disconnect the
appliance from the power supply.
•
CAUTION: Accessible parts may become hot during use
with cooking appliances.
•
Use only the fixing screws supplied with the appliance if
not supplied, use the screws recommended in the
installation instructions.
•
Do not use adhesives to fix the appliance.
•
The minimum distance between the hob surface on which
the pans stand and the lower part of the appliance shall be
at least 65 cm, unless otherwise specified in the
installation instructions for the appliance or hob.
•
The discharge of air must comply with local authorities
regulations.
•
Ensure good air ventilation in the room where the
appliance is installed to avoid the backflow of unwanted
gases into the room from appliances burning gas or other
fuels, including open fires.
•
Make sure that the ventilation openings are not blocked
and the air collected by the appliance is not conveyed into
a duct used to exhaust smoke and steam from other
appliances (central heating systems, thermosiphons,
water-heaters, etc.).
•
When the appliance operates with other appliances the
maximum vacuum generated in the room should not
exceed 0.04 mbar.
•
Make sure not to cause damage to the mains cable.
Contact our Authorised Service Centre or an electrician to
change a damaged mains cable.
•
If the appliance is connected directly to the power supply,
the electrical installation must be equipped with an
isolating device that allows to disconnect the appliance
from the mains at all poles. Complete disconnection must
comply with conditions specified in the overvoltage
category III. The means for disconnection must be
incorporated in the fixed wiring in accordance with the
wiring rules.
53