Junkers Ceraclass midi ZS 24-2 DH AE 23, Инструкция по установке и эксплуатации

Страница: 14 / 36

B
ÿ 40 cm
A Front ÿ 0.5 cm, side ÿ 1 cm
B
ÿ 10 cm
4.6 Installation of the boiler
4.4 Mounting the wall mount bracket
4.3 Minimum distances
4.5 Installing pipes
6 720 608 487
Installing
B Use the pre-assembly technique for the correct
positioning of the pipes.
14
B For filling and emptying the system on the side
B The pipes will be connected without voltage.
B Fix the wall mounting bracket to the wall with the supplied
screws and dowels - the screws will not be tightened to the
maximum.
FIG. 8 Wall mounting assembly
will be dimensioned in such a way as to ensure a
sufficient flow of water at the places of consumption
depending on the supply pressure.
B Wash piping to remove debris.
B Remove the wall mount bracket.
installation and maintenance - for this, observe the
information regarding the minimum distances specified
in Fig. 7.
B Remove the package and follow the instructions
on the package.
B Attach the wall bracket to the appropriate position in the
room (see section 4.3).
B Mark the positions and make holes for the wall mount
bracket.
fixing to the wall, then tighten all screws.
pipe waste residues
Wall mounting
B Check the orientation and position of the stand for
can damage the plant!
Careful:
B The maximum distances from all surface unevenness
(hoses, pipes, wall protrusions, etc.) must be observed.
B Ensure unobstructed access to the works
B Check the contents of the package to see if it is complete.
B The gas pipes must be dimensioned in such a way as to
ensure the supply of all connected appliances.
The following conditions will be taken into account when
determining the location:
FIG. 7 Minimum distances
B Domestic hot water pipes and taps
A filling and drain valve shall be installed at the lowest point
in the system.
Machine Translated by Google