CAUTION:
Replace a failed power supply with a new power supply within
five minutes of removal to prevent chassis overheating.
Step 7: Install the OSC SFP
To install and connect the OSC SFP to the OSC 0:
NOTE:
All fiber-optic cable connectors should be inspected and cleaned
prior to performing any optical connections, see the TCX1000 Programmable
ROADM Hardware Guide for instructions.
1.
Prevent ESD damage to your equipment by attaching an ESD grounding strap to your
bare wrist, and then connecting the strap to an approved site ESD grounding point.
2.
Verify that the OSC SFP transceiver is covered by a rubber safety cap. If it is not, cover
the transceiver with a safety cap.
3.
Carefully align the transceiver with the slots in the component. The connectors should
face the component. See
.
4.
Slide the transceiver until the connector is seated in the component slot. If you are
unable to fully insert the transceiver, make sure the connector is facing the right way.
Close the ejector handle of the transceiver.
Figure 9: Installing the OSC SFP
g009746
WARNING:
Do not look directly into a fiber-optic connector or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables
connected to transceivers emit laser light that can damage your eyes.
5.
Remove the rubber safety cap from the transceiver.
Copyright © 2018, Juniper Networks, Inc.
12
TCX1000 Programmable ROADM Quick Start Guide