Figure 1: Installing the Chassis on a Rack
g00
9
4
96
Step 4: Install the TCX1000-2D8CMD in the Chassis
To install the TCX1000-2D8CMD in the chassis:
1.
Attach the ESD grounding strap to your bare wrist and to a site ESD point.
2.
Remove the blank cover by pulling the knobs of the snap latch (located on either side) and pulling the cover out. See
Figure 2
.
Figure 2: Removing the Blank Cover from the Module Slot
g100051
3.
Lift the TCX1000-2D8CMD and carefully align it with the slot in the chassis, as shown in
Figure 3
.
Figure 3: Installing the TCX1000-2D8CMD in the Chassis
g00
9
4
91
4.
Slide the TCX1000-2D8CMD until it is fully seated in the slot. Push the knobs in fully on the snap latch (located on either side)
to lock in the TCX1000-2D8CMD.
5.
Install additional modules if needed by following the same steps. You can install up to three modules in the chassis.
3
Copyright © 2018, Juniper Networks, Inc.
TCX1000 2-Degree 8-Channel Multiplexer Quick Start Guide
