Juniper SSG140, Руководство по установке и настройке оборудования

Страница: 37 / 60

Tools and Parts Required
„ 37
Chapter 4
Servicing the Device
This chapter describes service and maintenance procedures for the SSG 140 device.
It includes the following topics:
„ “Tools and Parts Required” on page 37
„
“Replacing a PIM” on page 38
„ “Upgrading Memory” on page 40
„ “Replacing the Fuse” on page 43
Tools and Parts Required
To replace a component on an SSG 140 device, you need the following tools and
parts:
„ Electrostatic bag or antistatic mat
„ Electrostatic discharge grounding wrist strap
„ Flat-tip screwdriver, 1/8 inch
„ Number-2 phillips screwdriver
NOTE:
For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide . The instructions in the guide warn you about situations that
could cause bodily injury. When working on any equipment, be aware of the
hazards involved with electrical circuitry, and follow standard practices for
preventing accidents.