Juniper SRX5600, Руководство по оборудованию

Страница: 347 / 483

Replacing SRX5600 Services Gateway XFP and SFP Transceivers
To replace an XFP or SFP transceiver, perform the following procedures:
1.
Removing an SRX5600 Services Gateway SFP or XFP Transceiver | 350
2.
Installing an SRX5600 Services Gateway SFP or XFP Transceiver | 352
Removing an SRX5600 Services Gateway SFP or XFP Transceiver
Transceivers are installed in a MIC or SPC. Transceivers are hot-insertable and hot-removable. Removing
a transceiver does not interrupt the functioning of the card, but the removed transceiver no longer receives
or transmits data.
Before you begin to remove a SFP or XFP transceiver:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 453 .
Ensure that you have the following available:
•
ESD grounding strap
•
Replacement transceiver or transceiver slot plug
•
Antistatic mat
•
Rubber safety cap for the transceiver
•
Needle-nose pliers
To remove a transceiver (see Figure 145 on page 351 ):
1. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
2. Label the cables connected to the transceiver so that you can reconnect them correctly later.
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
350