Juniper SRX340, Руководство по оборудованию

Страница: 89 / 150

•
Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard on page 67
•
Connecting to the SRX340 Services Gateway from the CLI Remotely on page 71
•
Configuring the SRX340 Services Gateway Using the CLI on page 71
Connecting to the SRX340 Services Gateway from the CLI Remotely
To connect the services gateway to a network for out-of-band management:
1.
Plug one end of an Ethernet cable with RJ-45 connectors into the MGMT port on the
front panel of the services gateway.
2.
Plug the other end of the cable into the management device.
Related
Documentation
SRX340 Services Gateway Software Configuration Overview on page 63
•
•
Understanding SRX340 Services Gateway Factory-Default Settings on page 64
•
Viewing SRX340 Services Gateway Factory-Default Settings on page 64
•
Accessing J-Web on the SRX340 Services Gateway on page 66
•
Configuring the SRX340 Services Gateway Using the J-Web Setup Wizard on page 67
•
Accessing the CLI on the SRX340 Services Gateway on page 69
•
Configuring the SRX340 Services Gateway Using the CLI on page 71
Configuring the SRX340 Services Gateway Using the CLI
This sample procedure explains how you can create an initial configuration using CLI
commands to connect the SRX340 Services Gateway to the network.
1.
Verify that the device is powered on.
2.
Log in as the root user. Do not enter a password.
3.
Start the CLI.
root@% cli
root>
4.
Enter configuration mode.
configure
[edit]
root#
5.
Set the root authentication password by entering a cleartext password, an encrypted
password, or an SSH public key string (DSA or RSA).
[edit]
root#
set system root-authentication plain-text-password
New password: password
Retype new password: password
6.
Configure an administrator account on the device. When you are prompted, enter the
password for the administrator account.
71 Copyright © 2016, Juniper Networks, Inc.
Chapter 18: Performing the Initial Configuration