Juniper SRX100, Руководство по оборудованию

Страница: 102 / 154

■
Using the Reset Config Button on the SRX100 Services Gateway on page 85
■
Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 86
■
Juniper Networks Technical Assistance Center on page 87
Monitoring the SRX100 Services Gateway Power System
The LEDs on the services gateway enable you to determine the performance and
operation. The Power LED, located on the front panel of the services gateway,
indicates the different settings with respect to the power system.
Table 31 on page 84 describes different Power LED status settings and their corrective
actions.
Table 31: Services Gateway Power LED Status
Possible Cause and Corrective Action Meaning LED Status
Normal indication. No action is required. Device is receiving power, and the
internal power supply is functional. Green
Normal indication. No action is required. Indicates that the power button has
been pressed and quickly released. Amber
■
Verify that the AC power cord from the power
source to the device is not damaged. If the
insulation is cracked or broken, immediately
replace the cord or cable.
■
Ensure that the socket you plug in is in
working condition.
■
Ensure the device has an AC input voltage
between 100 and 240 VAC.
■
If you cannot determine the cause of the
problem or need additional assistance, see
“Juniper Networks Technical Assistance
Center” on page 87.
Indicates that the device is not
receiving power. Off
Related Topics
■
Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 79
■
Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
■
Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
■
Using the Reset Config Button on the SRX100 Services Gateway on page 85
■
Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 86
■
Juniper Networks Technical Assistance Center on page 87
84 ■
Monitoring the SRX100 Services Gateway Power System
SRX100 Services Gateway Hardware Guide