NOTE:
The RJ-45 management port,
em0
, and SFP management port,
em1
, are found on the management panel
of the PTX10002-60C. They are both labeled
MGMT
.
10.
(Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@#
set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
11.
Enable Telnet service.
[edit]
root@#
set system services telnet
NOTE:
When Telnet is enabled, you cannot log in to a PTX10002-60C through Telnet using root credentials. Root
login is allowed only for SSH access.
12.
Commit the configuration to activate it on the PTX10002-60C.
[edit]
root@#
commit
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the PTX series documentation
a
t
https://www.juniper.net/documentation/en_US/release-independent/junos/information-products/pathway-pages/ptx-series/product/
.
WARNING:
Failure to observe the following safety warnings can result in personal injury or death:
•
Permit only trained and qualified personnel to install or replace device components.
•
Perform only the procedures described in this Quick Start Guide and the PTX10002-60C documentation. Other
services must be performed only by authorized service personnel.
•
Before installing the device, read the planning instructions in the PTX10002-60C documentation to make sure
that the site meets power, environmental, and clearance requirements for the device.
•
Before connecting the device to a power source, read the installation instructions in the PTX10002-60C
documentation.
•
Before installing or after removing an electrical component, always place it component-side up on an antistatic
mat placed on a flat, stable surface or in an antistatic bag.
•
Do not work on the device or connect or disconnect cables during electrical storms.
•
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and
watches. Metal objects heat up when connected to power and ground and can cause serious burns or become
welded to the terminals.
Power Cable Warning (Japanese)
Copyright © 2018, Juniper Networks, Inc.
8
PTX10002-60C Quick Start Guide
