•
Before installing the optical ILA, read the planning instructions in the optical ILA documentation to make sure that the
site meets power, environmental, and clearance requirements for the optical ILA.
•
Before connecting the optical ILA to a power source, read the installation instructions in the optical ILA documentation.
•
If the rack or cabinet has stabilizing devices, install them in the rack before mounting or servicing the optical ILA in the
rack or cabinet.
•
Before installing or after removing an electrical component, always place it component-side up on a flat antistatic mat
or in an antistatic bag.
•
Do not work on the optical ILA or connect or disconnect cables during electrical storms.
•
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches.
Metal objects heat up when connected to power and ground and can cause serious burns or become welded to the
terminals.
Power Cable Warning (Japanese)
The attached power cable is only for this product. Do not use this cable for another product.
g040300
Contacting Juniper Networks
For technical support, see:
http://www.juniper.net/support/requesting-support.html
Juniper Networks, the Juniper Networks logo, Juniper, and Junos are registered trademarks of Juniper Networks, Inc. in the
United States and other countries. All other trademarks, service marks, registered marks, or registered service marks are the
property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this document. Juniper
Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Copyright © 2020
Juniper Networks, Inc. All rights reserved. Rev. 01, June 2020.
6