Juniper NSM4000, Руководство по оборудованию

Страница: 21 / 196

Table 5: NSM4000 Appliance Rear Panel Components (continued)
Description Component
The appliance power switch is used to power
on or power off the appliance. Power switch
An empty power supply module slot is provided
so that a second power supply module can be
added, for redundancy, if needed. Redundant power supply module slot
A single AC power supply module is shipped
with the appliance and provides power to the
appliance. However, the appliance can also be
run on DC by using the DC power supply module
for the NSM4000 appliance. Power supply module
One LED is present on the power supply
module:
• Green indicates that the power supply
module is powering the appliance.
• Amber indicates that the power supply
module is on but it is not powering the
appliance (standby mode).
Power Supply Module LED
Related
Documentation
Front Panel of an NSM4000 Appliance on page 4
•
•
NSM4000 Ethernet Interfaces Overview on page 7
•
NSM4000 Appliance Overview on page 3
NSM4000 Ethernet Interfaces Overview
An NSM4000 appliance has four Ethernet interfaces; three interfaces can be used and
one is reserved for future use. The Ethernet interfaces are labeled
0 , 1 , 2 , and 3 for the
NSM4000 appliance.
You can use the Ethernet interfaces as follows:
•
eth0—Use the eth0 interface to configure the virtual IP (VIP) address of a fabric and
the IP address of the node as well as to access the managed devices. The VIP address
and the IP address of the node should be on the same subnet.
The eth0:0 subinterface provides access to the NSM4000 Network Management
Platform GUI. You can access the GUI by using the VIP address of the fabric.
• eth1—Use the eth1 interface as an administrative interface for an NSM4000 node. Use
SSH to access an NSM4000 node through this interface. The eth0 interface and the
eth1 interface can be on different subnets.
If you configure eth1, you cannot access the NSM4000 nodes using the eth0 interface.
You can access the CLI of the NSM4000 virtual appliance only through the eth1
interface.
7 Copyright © 2016, Juniper Networks, Inc.
Chapter 1: NSM4000 Appliance Overview