Juniper MX2008, Быстрый старт

Страница: 11 / 69

Step 2: Install the Mounting Hardware
A mounting shelf is required for installing the router in a four-post rack or cabinet. The
shelf is not required for installing the router in an open-frame rack.
1.
Slide the large shelf between the rack rails, resting the bottom of the shelf on the rack
supports. The large shelf installs on the rear rack rails, extending toward the front of
the rack.
NOTE: There must be a minimum of 24-U unobstructed front-to-back
usable rack space when installing the MX2008 router into a four-post
rack or cabinet.
2.
Partially insert screws into the open holes in the rear flanges of the four-post mounting
shelf (see
Figure 6 on page 12 ).
NOTE: Depending on the type of rack or cabinet you have, cage nuts might
be required.
3.
On the front of each front rack rail, partially insert a mounting screw into the holes in
each ear of the four-post mounting shelf (see
Figure 6 on page 12 ).
4.
Tighten all the screws completely.
11 Copyright © 2017, Juniper Networks, Inc.
Step 2: Install the Mounting Hardware