Juniper LN1000 - RELEASE NOTES 8-27-2010, Руководство пользователя

Страница: 45 / 64

To remove an SFP:
1.
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
SFP. Have ready a rubber safety cap for the SFP transceiver and the cable.
2.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
3.
Label the cable connected to the SFP so that you can later reconnect it to the correct
SFP.
4.
Disconnect the cable from the SFP. Immediately cover the transceiver and the end
of the cable with a rubber safety cap.
5.
Arrange the cable to prevent it from dislodging or developing stress points. Secure
the cable so that it is not supporting its own weight as it hangs to the floor. Place
excess cable out of the way in a neatly coiled loop. Placing fasteners on the loop helps
to maintain its shape.
6.
Pull the ejector handle away from the SFP faceplate to unseat the SFP from the RTM.
Pull the SFP out of the RTM and place it on the antistatic mat or in the electrostatic
bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30
seconds before reinserting it or inserting a transceiver into a different slot.
Issue the
show chassis hardware detail command to verify the installed
transceivers.
Cabling the LN1000 Rear Transition Module
To cable the LN1000 rear transition module, you need the following items:
•
RJ-45-to-DB-9 adapter (provided)
• External power supply
• Up to nine copper Ethernet cables with RJ-45 connectors: one cable to connect to the
console port and eight cables to connect to the gigabit Ethernet ports. (These cables
are not provided with the router hardware.)
To cable the LN1000 rear transition module:
1.
Insert one end of the console cable with an RJ-45 connector into the NPU console
connector port on the front panel of the rear transition module.
2.
Insert the RJ-45-to-DB-9 adapter on the other end of the console cable.
3.
Insert the DB-9 adapter into the serial port on your PC.
4.
Insert the RJ-45 connectors on the copper Ethernet cables into the Ethernet ports on
the front panel of the rear transition module.
31
Chapter 7: Installing the LN1000 Rear Transition Module