Juniper JRR200, Руководство по оборудованию

Страница: 41 / 108

Table 22: Parts List for a Fully Configured JRR200 Route Reflector
Quantity Component
1 Route reflector
2 AC or DC Power supply (pre-installed)
2 AC power cord appropriate for your geographical location (only for AC
models)
1 Rack mount kit
1 Quick Start installation instructions
1 Juniper Product ROHS and Warranty Document
1 End User License Agreement
1 Safety Guide
1 RJ-45 to DB-9 serial port adapter
2 RJ-45 cables
Installing the JRR200 Route Reflector in a Rack
You can mount the route reflector on four posts in a 19-in. rack or cabinet by using the
rack-mount kit shipped with the device. (The remainder of this topic uses rack to mean
rack or cabinet.)
Before mounting the JRR200 route reflector on four posts in a rack:
1.
Verify that the site meets the requirements described in “Site Preparation Checklist
for the JRR200 Route Reflector” on page 29 .
2.
Place the rack or cabinet in its permanent location, allowing adequate clearance for
airflow and maintenance, and secure it to the building structure.
3.
Verify that the rack or cabinet meets the specific requirements described in “JRR200
Rack and Cabinet Requirements” on page 34 .
4.
Remove the JRR200 route reflector from the shipping carton (see “Unpacking the
JRR200” on page 40 ).
Ensure that you have the following parts and tools available:
• Electrostatic discharge (ESD) grounding strap
• Screws to secure the mounting brackets to the chassis
•
Rack-mounting screws to secure the chassis to the four rack posts—not provided
41 Copyright © 2018, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration